Bissell 15D1A EasySweep Cordless Floor & Carpet Sweeper

Owner's Manual

The Bissell 15D1A EasySweep Cordless Floor & Carpet Sweeper provides you with a convenient, simple way to pick up daily dirt and unexpected dry messes between routine vacuuming. The rotating brush on this carpet sweeper is battery-powered and can quickly sweep large and small debris. This cordless floor sweeper has a slim design, making it perfect for nearby closets (or leaving it out) for quick cleaning throughout the week. Its no-touch dirt container enables you to press a button on the top of the foot to release its contents into the trash without needing to make contact with the mess.

To assemble the EasySweep, start with the handle. Assemble the handle by taking the section with the non-slip grip and the middle section which has grey connector pieces on each end, and insert the middle section into the grip section. Twist to tighten into place, and insert this newly-assembled section into the hole in the bottom section. Twist to tighten it into place.

Take the assembled handle and line up the bottom hole with the button on the swivel connector on top of the EasySweep. Push the button on the swivel connector down while pushing the assembled handle over the button, locking the handle into place.

Fully charge your EasySweep before using. To charge the unit, plug the charger into a standard electrical outlet. Plug the opposite end into the charging port on the back of your EasySweep. The charging indicator light will illuminate once it’s properly connected and will not turn off when it’s fully charged. Note: the power switch must be in the OFF position while it’s charging.

When you charge your PerfectSweep, allow it to charge at least 16 hours every time. Decreased operating time may indicate that the battery has built up a resistance. To recharge, completely exhaust the battery, recharge it, and then exhaust it again before you recharge it a second time. This may be required more than once.

Part numbers and Alternate Part numbers